Abstract:
The combination of calcium looping and concentrating solar power (CSP) is a promising energy conversion technology that can greatly increase the share of solar energy used in combined cooling, heating and power (CCHP) systems. This paper designs a CCHP system based on solar energy and thermochemical energy storage. The system runs all day through day and night modes. Under basic working conditions, the energy and exergy efficiencies of the system could reach 56.92 % and 35.94 %, respectively. The system is evaluated by multiple approaches including parametric sensitivity analysis and 4E (energy, exergy, economy and environment)) analyses. The results demonstrate that the system could produce 2618.09 MW of electricity, 305.56 MW of heat and 523.88 MW of cooling capacity per day, respectively. At the same time, the reductions of CO2 emissions and fossil fuel consumption could reach 2222.76 tons and 696.41 m3 per day, respectively. Furthermore, the increasing mass flow of main turbine inlet could increase both the system efficiency and the exergy efficiency. Thus, it is beneficial to reduce the environmental impact but with the increasing investment cost. In the meanwhile, the exergoeconomic factor and exergoenvironment factor of the system were 55.65 % and 0.139, respectively. Besides, as the extraction flow rate of the intermediate pressure turbine increases, the energy efficiency increases but the exergy efficiency descends. This is unfavorable to reducing the environmental impact, yet it could decrease the investment cost of the system. These results reveal that the hybrid system has the characteristics of high efficiency and emission reduction in energy storage, power generation, heating and cooling, and has great development potential.
Zhang, D., Yang, X., Li, H., Jia, Z., Zhang, S., Tang, S., Liu, D., & Wu, X. (2024). 4E analysis and parameter study of a solar-thermochemical energy storage CCHP system. Energy Conversion and Management, 301, 118002. https://doi.org/10.1016/j.enconman.2023.118002